An earlier version of this applicator coil is shown here. It is of interest because it shows more about how the coil is wound, how the snorkel is fabricated, etc.
Airflow Directors are Mounted
RG-134 Coax is Attached, Hot Glue is Added
Hot Glue is Added to Both Sides of the High Voltage Connection
A 6-32 Set Screw Will Anchor the Applicator Coil Assembly
A Cut Coil Cover is used to verify 3/16" inch spacing between coil and cover
Applicator Coil Assembly is Installed
Side Holes Minimize Chance of Accidental Airflow Blockage
Applicator Coil Fan, 12 Volts 1.6 Amps
Fan Housing directs airflow into Applicator Coil hose.